Back
Previous product
Stacked Slate Spillway Wall 32″ Landscape Fountain Kit
Next product
GATOR SUPERSAND G2

GATOR SUPERSAND BOND

SUPERSAND BOND is a unique mixture of polymer binders and calibrated sand available in Beige and Slate Grey. The installation of SUPERSAND BOND is almost identical to using regular paver joint sand except for the application of water. Once SUPERSAND BOND polymeric sand sets, it becomes very firm and locks between the paver joints while still retaining flexibility and providing a long lasting, durable jointing material. SUPERSAND BOND is recommended for a variety of uses including pool decks, patios, footpaths, driveways, parking spaces, pavements etc.

FOR CONCRETE PAVER JOINTS UP TO 1″ IN TRADITIONAL APPLICATIONS

Category: Brand:
Description

Description

IMPORTANT INSTALLATION NOTES

  1. Always refer to the latest SUPERSAND BOND Technical Data Sheet (TDS) at AllianceGator.com before installing SUPERSAND BOND.
  2. Pavers and slabs must be installed according to ICPI Tech Spec #2 (www.icpi.org) before SUPERSAND BOND installation. If pavers are installed over a concrete slab, (overlay application) Gator Maxx polymeric sand must be used. (Offered in USA only)
  3. Traditional Base application, using SUPERSAND BOND for pavers’ sides and top surfaces must be completely dry. Do not apply if the paver surface is damp or wet. The damp or wet surface will cause SUPERSAND BOND to prematurely activate and will lead to the polymers sticking on the paver surface.
  4. Do not apply if the paver joints are damp or wet. This will prevent the SUPERSAND BOND from properly sliding into the joints and obtaining very densely packed joints, which is critical to the products performance.
  5. Temperature must be above 32°F (0°C) with dry conditions (no rain for at least 1 hour) after installing SUPERSAND BOND.
  6. For all paver surfaces, and particularly around in-ground pools there must be a slope of 1/8″ (3 mm) per linear foot away from the edge of the pool, or structures to ensure optimal performance of the SUPERSAND BOND.
  7. For the pool coping units it is mandatory to use mortar in the joints. For the rest of the paver installation around the pool, you can use SUPERSAND BOND.
  8. Do not sweep SUPERSAND BOND over asphalt.
  9. SUPERSAND BOND level, must be at least 1/8″ (3 mm) below top of paver’s surface or 1/8″ (3 mm) below the chamfer or erosion may occur. The filled and cured polymeric sand joints should never be in direct contact with foot traffic or tires.
  10. For textured or pre-finished surfaces, we recommend to remove all the sand from the paver or slab surface prior to using the plate or roller compactor.
PLEASE NOTE:
All pavers must be completely interlocked for vehicular and pedestrian use. If pavers are fanned they are not considered interlocked. SUPERSAND BOND can be applied when pavers are installed directly on open graded aggregates that lock or choke themselves. This means the polymeric sand will not migrate through the voids. Do not apply SUPERSAND BOND when the pavers are installed directly on aggregates with large voids.